DESIGN / CONSTRUCTION: AMBER Series FD Two Phase capacitors in ‘Resin Encapsulated – Dry Type’ design are manufactured out of modules made of Low Loss Self-Healing Metallized Polypropylene Film encapsulated in resin. The modular construction allows repair / maintenance of the assembly at the component level.
DISCHARGE RESISTORS: Fitted to reduce the residual voltage from peak voltage to 50V or less within 5 minutes of switch-off.
COOLING: Air cooled self-ventilation type AN.
TERMINATION: Plated Brass Terminals, M12, to withstand maximum torque of 15.5Nm
HOUSING: Electrostatically Powder Coated MS sheet, 1 mm.
|SPECIFICATIONS||IEC 60110-1(1998-06), IEC 60110-2(2000-02), UL 810|
|TEMPERATURE CATEGORY||-25ºC / +40ºC
Lower Category temperature: -25°C
Upper Category temperature: 40°C
|CAPACITANCE TOLERANCE||± 5% & ±10% (other tolerances available on request)|
|RATED VOLTAGES||880, 1320 VAC (Other Voltages on request)|
|RATED FREQUENCIES||50 Hz (60Hz on request)|
|LOSSES||Less than 0.8 W / kVAr|
|CONTINUOUS OVER-VOLTAGE||The capacitors shall not be operated at terminal voltage exceeding the rated voltage.|
|MAXIMUM POSSIBLE VOLTAGE||1.05 x rated voltage of 1 hour per day|
|MAXIMUM POSSIBLE CURRENT||1.25 x rated voltage of 1 hour per day|
|TEST VOLTAGE||Between terminals: 2.15 Un AC for 10 seconds
Between terminals and case: 3 kV, for 10 seconds
WARNING: Capacitor replacement may be hazardous since residual voltage may be present across the capacitor terminals. Always discharge capacitors by short-circuiting the terminals with an insulated wire, even though discharge resistors may have been provided.
ATTENTION: Capacitors covered by this catalog comply with international standards such as IEC, VDE, BS, EN, UL etc. It is the user’s responsibility to take utmost care both in the selection of capacitors for a particular usage, and their correct installation. AMBER shall not be liable for any consequential damages occurring for any reasons what-so-ever.
NOTE: Due to continuous research and development in our technology, the data and sizes given in this catalog may be changed without prior notice.
Please reconfirm the dimensions with AMBER if this information is crucial for your application.
Please contact AMBER for your requirements of non-standard working voltages, capacitance values, container dimensions, lead-lengths, tolerances, etc.
CATALOGUE NUMBERS/ORDERING CODES: